Moravia - TRAFFIC-LINE Cable/Hose Protection Ramps – 3 Channel

Drive over cables, hoses and pipes without causing them harm. The TRAFFIC-LINE Cable/Hose Ramp is produced in a hard wearing combination

of rubber and polyethylene (PE).

It has non-slip surface features and includes 3 cable/hose channels. The PE lid is hinged so that the cables/hoses can be easily laid into the body of the ramp, whilst the lid, moulded in bright yellow PE, has a highly effective signalling effect.

They are widely used on construction sites, distribution depots, emergency works, road works etc.

The ramp is suitable for HGV use having been tested to take 10 tonne axle weight. Drive over height is 75 mm – recommended speed 3–5 mph.

Specification:

Size (mm): Centre section: 600 L x 960 W* x 75 H *Net width 885 mm Cross-over section: 597 L x 740 W* x 75 H * Net width 597 mm

45° angle: 600 L x 500/200 W x 75 H End section female: 600 L x 230 W x 75 H male: 600 L x 220 W x 75 H

Channels: 3 See drawing for sizes. Material: Body: Hard rubber Cover: Polyethylene (PE)